Brentwood is about 12 miles from Nashville in Williamson County, and its subdivisions along the Little Harpeth River, Mill Creek and Owl Creek saw floodwater in May 2010. Most HVAC mold here, though, comes from condensation and drain problems rather than floods, and removal means cleaning or replacing the affected parts and fixing the moisture. Call the number on this page to be connected with a local mold remediation company in Brentwood.

Why would only one system in my Brentwood house smell musty?
Many larger homes run separate systems for the main floor and the upstairs, often with one air handler in a crawl space or basement and another in the attic. Each has its own coil, pan and drain, and each faces different conditions. The lower unit sits in damp air near the ground, where ducts can sweat. The attic unit works in extreme summer heat, where a leaky duct joint or a drain pan that overflows can wet insulation and drywall below. When only one zone smells, that tells the company where to start. Shut that system off, since EPA advises against running one you suspect is contaminated.
Did the May 2010 flood affect homes here?
Yes. About 16.6 inches of rain fell over two days, the Little Harpeth River flooded Brentwood's far west side, and Mill Creek and Owl Creek flooded the far east side, both areas mostly subdivisions. Williamson County notes that flash floods can come with little warning and that standard homeowner's policies don't cover flooding. If your house is near one of those streams and ductwork or equipment sits below the main floor, check FEMA's Flood Map Service Center for your property and have the system looked at after any serious high water.
What does a proper remediation job look like?
A sound scope starts with inspecting each air handler and the duct runs the company can reach, then explains what caused the growth. Metal ducts and plenums can usually be cleaned. EPA says wet or moldy duct board and internal duct liner generally can't be, so those get replaced, as does moldy flex duct. The drain, insulation or humidity problem is fixed before the system restarts. Angi reports national ranges of about $600 to $2,000 for duct mold cleaning and $3,000 to $10,000 for HVAC system mold work; prices around Brentwood vary.

Local permits and complaints
Replacing ductwork or equipment may need a permit from the City of Brentwood Planning and Codes Department, which has an online permitting portal. Its Codes Enforcement Section handles property maintenance and nuisance code violations, reported through the city's Citizen Comment Form.
HVAC & Air Duct Mold Removal questions in Brentwood
Can moldy duct liner or duct board be cleaned?
What indoor humidity keeps mold out of the system?
What should I check before hiring a company for duct mold work in Tennessee?
Will homeowners insurance pay for mold in my HVAC system?
More mold services in Brentwood
HVAC & Air Duct Mold Removal nearby
Helpful guides
Sources
- Williamson Herald: Flood impact from 10 years ago still felt
- Williamson County: Flooding
- City of Brentwood: Codes Section
- City of Brentwood: Codes FAQs
- EPA: Should You Have the Air Ducts in Your Home Cleaned?
- EPA: Mold Cleanup in Your Home
- Angi: How Much Does Mold Remediation Cost? (2026 data)
- Tennessee Contractor Classification Outline (TDCI)
- TDCI: Bidding FAQs
Last updated: